Hi. Is it possible to install the spring vibration isolator in a Mustang II front end.without separating a ball joint from the spindle? Just looking for an easy route
I wasn’t trying to be blunt but I don’t have an option for you. I have a home made spring compressor I would give you but too far away. So take out shock undo bottom ball joint and lower out the spring. Good luck !
Hi. I was hoping that I could compress the spring enough to get them in. I have a set of home made spring compressors. Last time I removed the ball joint with a pickle fork I buggered up the ball joint and had to replace it. I was hoping there was another way, but as you said - there isn’t.
Don't use a pickle fork, but rather make a jack screw out of a couple bolts and a coupling nut. like this ball joint jack.
Or I have one of these which can also be used for rod ends. Princess Auto BJ separator.