Mustang II spring isolator installation

Ken47

Ken47

Active Member
Supporting Member
Hi. Is it possible to install the spring vibration isolator in a Mustang II front end.without separating a ball joint from the spindle? Just looking for an easy route😄😄
 
I wasn’t trying to be blunt but I don’t have an option for you. I have a home made spring compressor I would give you but too far away. So take out shock undo bottom ball joint and lower out the spring. Good luck !
 
Hi. I was hoping that I could compress the spring enough to get them in. I have a set of home made spring compressors. Last time I removed the ball joint with a pickle fork I buggered up the ball joint and had to replace it. I was hoping there was another way, but as you said - there isn’t. 😄😄
 
I wonder if the spring could be compressed enough to slide the isolator in ?
 
You must log in or register to reply here.
Back
Top Bottom