In depth DISCUSSION on BUILDING a FLAT HEAD ENGINE

[Digger_Dave]

On the old CR "REFERENCE" section I had posted a piece about ...

"In depth DISCUSSION on BUILDING a FLAT HEAD ENGINE"

This originally appeared on the HAMB, (another "ROD" board) but was POSTED even before the original CR was started.

It starts rather slow, but it eventually turns into a MAJOR FLAT HEAD REFERENCE information piece.

So ... once again, here it is ...

http://www.jalopyjournal.com/forum/showthread.php?t=23305&showall=1

Watch for aV8 - (Mike Bishop) pieces on "Porting and Polishing a Flat Head"
Plus contributions of MANY others.

 

[Old-Soul]

very informative, thanks!

 

[flatcat]

Really enjoyed the post, many thanks.